Stetsom BRAVO FULL 12K 2 Ohm – Extreme-Power Full-Range Digital Amplifier

Take your high-output car audio system to the next level with the Stetsom BRAVO FULL 12K 2 Ohm, an extreme-power full-range mono Class-D amplifier engineered for demanding SPL, bass and high-output automotive sound systems.

The 2-ohm BRAVO FULL 12000 is capable of producing 12,200 watts RMS at 2 ohms at 12.6V and an incredible 13,140 watts RMS at 2 ohms at 14.4V. Unlike a traditional subwoofer-only monoblock, its wide 5Hz–7kHz frequency response allows the BRAVO FULL 12K to be used with compatible subwoofers, woofers and high-output speaker systems.

If you're building a serious competition-style car audio system and need enormous output from a single-channel amplifier, the Stetsom BRAVO FULL 12K 2Ω is built for exactly that level of system.

🔥 OVER 12,000 WATTS RMS AT 2 OHMS

The BRAVO FULL 12K isn't using a misleading “max power” number as its primary rating.

For the 2-ohm version, Stetsom publishes the following RMS output:

12,200W RMS × 1 @ 2Ω – 12.6V
12,350W RMS × 1 @ 2Ω – 13.8V
13,140W RMS × 1 @ 2Ω – 14.4V

At 4 ohms, output is:

6,770W RMS × 1 @ 4Ω – 12.6V
7,110W RMS × 1 @ 4Ω – 13.8V
7,115W RMS × 1 @ 4Ω – 14.4V

Minimum output impedance for this specific version is 2 ohms.

IMPORTANT: THIS LISTING IS FOR THE 2-OHM VERSION

Stetsom also makes a 1-ohm BRAVO FULL 12000, but it has different output ratings and a different minimum impedance.

This East Car Audio listing is specifically for:

BRAVO FULL 12000 – 2 OHMS

Do not operate the 2-ohm model below its specified 2-ohm minimum load.

🔊 TRUE FULL-RANGE AMPLIFIER

The BRAVO FULL series is different from a conventional bass-only monoblock.

Stetsom designed the line as a FULL-RANGE amplifier platform, and the BRAVO FULL 12000 has a published frequency response of:

5Hz–7,000Hz

That gives system builders much more flexibility than a traditional low-frequency-only monoblock. Stetsom describes the BRAVO FULL line as suitable for compatible subwoofers, woofers, drivers and tweeters, depending on the system design and crossover configuration.

For the safest East Car Audio copy, I would emphasize subwoofers, woofers and high-output speaker systems rather than encouraging customers to connect small tweeters directly to a 12,000-watt amplifier without a properly engineered system.

🎛️ ADJUSTABLE HPF + LPF CROSSOVERS

The Stetsom BRAVO FULL 12K gives installers extensive control over the frequencies being amplified.

High-Pass Filter (HPF): 5Hz–90Hz

Low-Pass Filter (LPF): 90Hz–7kHz

This allows the amplifier to be configured for different high-output system applications instead of limiting it to a fixed subwoofer frequency range.

💥 ADJUSTABLE BASS BOOST

Need additional low-frequency tuning?

The BRAVO FULL 12K includes an adjustable bass boost circuit:

Bass Boost Frequency: 30Hz–70Hz
Bass Boost Level: 0dB to +10dB

This gives installers additional control over the amplifier's low-frequency response.

Use bass boost carefully. On an amplifier capable of more than 13,000 watts RMS, improper gain, boost or crossover settings can quickly exceed the thermal or mechanical limits of the connected speakers.

🎚️ FLAT MODE

The amplifier also incorporates a FLAT mode.

According to Stetsom, enabling FLAT mode disables the settings made with the crossover and bass-boost controls.

That can be useful in systems where crossover and equalization duties are being handled externally by a dedicated DSP or processor.

⚡ MASSIVE ELECTRICAL SYSTEM REQUIRED

This is extremely important for anyone buying a BRAVO FULL 12K.

This is not an amplifier you should simply connect to a stock vehicle electrical system.

For the 2-ohm model, Stetsom publishes current consumption of approximately:

570A – Musical Signal
1,130A – Bass Signal

with an operating voltage range of 9–16V DC.

A properly engineered high-current electrical system is essential. Depending on the installation, that can involve appropriately sized:

High-Output Alternator(s) • Battery Bank • Lithium Battery System • Power & Ground Cable • Distribution • Fusing • Grounding

The exact electrical requirements should be calculated for the vehicle and intended operating conditions.

Professional installation is strongly recommended.

Stetsom itself instructs that installation should be performed by a qualified professional and that the amplifier should be installed in a firm, dry, ventilated location with unobstructed cooling.

❄️ ACTIVE COOLING

High-power amplifiers generate serious heat.

The BRAVO FULL 12000 incorporates active cooling fans to move air through the amplifier. Stetsom specifically warns installers not to obstruct the air inlets and outlets.

When designing an amp rack for this amplifier, make sure there is adequate ventilation around the chassis.

📢 HIGH-OUTPUT CAR AUDIO APPLICATIONS

The BRAVO FULL 12K 2Ω is designed for serious builds such as:

High-Power Subwoofer Systems • SPL Builds • Demo Vehicles • Large Woofer Systems • Pro-Audio Builds • Custom Truck Audio • Competition Systems • Multi-Subwoofer Systems

Its combination of huge output and full-range capability makes it particularly useful for specialized systems where conventional small car amplifiers simply don't provide enough power.

⚡ KEY FEATURES

• Stetsom BRAVO FULL 12000
• 2-ohm version
• Digital Class-D amplifier
• Mono / 1-channel
• Full-range design
• 12,200W RMS @ 2Ω / 12.6V
• 12,350W RMS @ 2Ω / 13.8V
• 13,140W RMS @ 2Ω / 14.4V
• 6,770W RMS @ 4Ω / 12.6V
• 7,110W RMS @ 4Ω / 13.8V
• 7,115W RMS @ 4Ω / 14.4V
• 2-ohm minimum impedance
• 5Hz–7kHz frequency response
• Adjustable HPF: 5Hz–90Hz
• Adjustable LPF: 90Hz–7kHz
• Bass boost: 0 to +10dB
• Adjustable bass-boost frequency: 30Hz–70Hz
• Input sensitivity: 200mV
• Input impedance: 19kΩ
• Signal-to-noise ratio: >90dB
• Operating voltage: 9–16V DC
• Active cooling
• Designed for extreme-output automotive sound systems

📊 STETSOM BRAVO FULL 12K 2-OHM SPECIFICATIONS

These specifications come directly from Stetsom's official BRAVO FULL 12000 manual, which includes separate data columns for the 1-ohm and 2-ohm versions.

📦 WHAT'S INCLUDED

1 × Stetsom BRAVO FULL 12K / 12000 2-Ohm Amplifier

I would avoid adding installation accessories to the “What's Included” section unless you've physically verified the contents of your East Car Audio inventory.

🛻 EXCELLENT FOR EXTREME TRUCK AUDIO BUILDS

For your East Car Audio audience, I would target this heavily toward large truck and demo builds.

The BRAVO FULL 12K can be incorporated into extreme custom systems in vehicles such as:

Chevy Silverado • GMC Sierra • Ford F-150 • Ram • SUVs • Demo Trucks • Competition Vehicles

This is a universal amplifier rather than a vehicle-specific product. Vehicle compatibility depends primarily on having enough mounting space and a properly designed electrical and audio system.

⭐ LOOKING FOR THE BEST PLACE TO BUY A STETSOM BRAVO FULL 12K 2 OHM?

Shop East Car Audio.

If you're searching for where to buy a Stetsom BRAVO FULL 12K, best place to buy a Stetsom 12000-watt amplifier, BRAVO FULL 12000 2-ohm amplifier, or a high-power full-range car audio amplifier, shop East Car Audio.

East Car Audio specializes in the equipment required for serious high-output car and truck audio systems, including Stetsom amplifiers, subwoofers, pro-audio speakers, high-current wiring, battery-system components, amp racks and custom truck-audio equipment.