Lease for as low as $/week
1-4 DAYS DELIVERY
CODE: AE029
Categories: Best Sellers!
100% ORIGINAL AND QUALITY
24 MONTHS GUARANTEE
- Description
- Shipping and Refund
Forget about the hacks. This is a real solution!
- Easy 100% plug-and-play installation
- Maintains start-stop button functionality
- No parasitic battery drain
- Doesn't disable Active Fuel Management (AFM)
- Works with all gas and diesel engines
- Withstands extreme hot and cold temperatures
- 60-Day money back guarantee
- Free domestic shipping
✔ In Stock
Beware of the knockoffs being sold elsewhere as "Start/Stop Eliminators". These are not our products, and they do not work correctly.
The Autostop Eliminator is an intelligent device that plugs into the back of your vehicle's auto stop-start switch assembly. It restores your preference for auto start-stop automatically which eliminates the need to press the button after each ignition cycle.
Unlike diagnostic port solutions for GM vehicles, our device will not:
- Disable the malfunction indicator light (check-engine light)
- Drain the battery
- Disable Active Fuel Management (AFM)
- Interfere with airbag functionality
- Keep the vehicle in diagnostic mode
INSTALLATION INSTRUCTIONS:
Accessing the switch may seem a little intimidating to some, but it's actually not bad. First-time installers can usually install the device in 30 minutes or less. Experienced installers can install it in about 15 minutes.
The installation process for a 2025 Tahoe is different from the video. The only reasonable way to install the device on a 2025 is via the side access panel. Removing the trim panel around the switch as we show in the video below is only a reasonable approach for the 2021-2024. We don't have a video for the 2025 yet, but customers have been successful using a long right-angle pick to release the red locking tab from the side. Once that's released, it's a tight fit, but you should be able to disconnect the connector by hand.
IF YOU HAVE A DENALI MODEL YOU WILL NOT REMOVE THE UPPER APPLIQUE. ONCE YOU HAVE THE SIDE FUSE BLOCK COVER REMOVED YOU WILL SEE 1 SCREW THAT IS HOLDING THE SWITCH PANEL IN. REMOVE THAT SCREW TO GAIN ACCESS
